So if this is the case (and I presume what was causing other error) is this how it should be or should I change a setting somewhere? I’m just trying to do the old test a bunch of squares for different powers and speeds and what not. I tried lowering the speed and anything below 190mm/sec seems to work without that issue. Buy ORTUR Laser Master 2 Pro S2 LU2-4 SF Laser Engraver, Laser Engraving Cutting Machine, DIY Laser Marking for Metal, Wood, Compresed Spot CNC, 32-bit Motherboard LaserGRBL(LightBurn), 400x400mm with fast shipping and top-rated customer service. I presume may be too fast to be that close to edge. I have the square at 9000 mm/s speed and 90 power fill.
I’ve tried it three times and the same thing happens. (Right-click the 'Devices' button to reset the connection) Ortur Laser Master 2 Pro using Lightburn LightBurn Hardware Compatibility OFFICIAL Ortur Lasers ali11759 (Alison K Schmidt) August 8, 2021, 9:00pm 1 The laser stops at about 36 of the job. G-code motion target exceeds machine travel. When I create new file and simple it down to one square and in corner I get this when I hit continue anyway it does not actually cut anything just gives this.
So is this perhaps part of the issue? I had 4 different little squares down there I had and was not working. They are used for high-speed marking or engraving, and may have a fiber laser source for metals, or a CO2 laser source for marking woods.
0 kommentar(er)
